Xiaobian recently moved and found that the new moving toilet has a strong moist and musty smell, the wall is moldy and serious, and the wall tiles are covered with black mildew on the top 50 cm. How to remove mildew? How to prevent and cure such problems?
Washing powder or toilet liquid
Bathroom tile moldy
The mildew and smell of the bathroom is because of the dampness and poor ventilation. Generally, the toilet in the old community is prone to similar situations. To remove mildew, first wet the moldy wall or floor with water , then sprinkle with washing powder or toilet solution, wait 5-10 minutes and then mop with a mop. However, it is inevitable that there are corners or gaps that are difficult to clean, or the mold spots are too long to be removed at one time. At this time, it can be scraped repeatedly with a knife or sandpaper, and then washed with detergent or toilet liquid.
To prevent such problems from recurring, first check the shower heads, water pipes, etc. to ensure no water leakage, dripping, and then open the doors and windows or exhaust fans to ensure the ventilation of the bathroom (for the old community part of the bathroom without windows, it is recommended to install the exhaust fan, or Open the door for ventilation). The last step is to clean up and prevent accumulation for a long time.
The outer wall of the bathroom is wet and the skin may be too low.
Moldy and peeling of the exterior wall of the bathroom
There are two reasons for the appearance of the above picture on the exterior wall of the bathroom: 1. There is a problem with the water pipeline inside the wall, and there is water seepage, which causes mold on the exterior wall of the bathroom. The probability of this cause is low; 2. The bathroom has no waterproof layer or waterproof layer. Low, the moisture in the bathroom penetrates into the wall.
If it is an internal water pipeline problem, it should be replaced in time, but it is quite troublesome to replace. If the problem is not particularly serious, you can choose to scrape off the exterior wall decoration and carry out moisture-proof treatment. If the bathroom does not have a waterproof layer or the waterproof layer is too low, it should be re-watered in the bathroom and enhance the waterproofing of special parts such as the yin and yang angles and the root of the toilet. For toilet water specification, reference may be prescribed "Residential decoration construction norms" of: bathroom wall waterproof layer shall not be less than 1800mm.
How to apply and store sunscreen
Apply 15 minutes before you go outside. This allows the sunscreen (of SPF 15 or higher) to have enough time to provide the maximum benefit.
Use enough to cover your entire face and body (avoiding the eyes and mouth). An average-sized adult or child needs at least one ounce of sunscreen (about the amount it takes to fill a shot glass) to evenly cover the body from head to toe.
Sunscreen
DELIN HAIR COSMETICS , https://www.arganshampoofactory.com